Legend / Backplane Question 1

[Pepperz]

On a 391C1 power supply, there is a hole next to the edge connector that allows a post from the backplane to fit into it when the power supply is installed on the backplane. If the backplane has no post, can a plastic post be improvised and inserted into the hole to provide the same purpose?
I know there is a switch inside the power supply that I suppose acts as an interlock so that the power supply provides no voltage on the edge connector when it is removed from the backplane, but I need to know for certain.

Thanks.

 

[merlinman]

It can be done, but I don't recommend it.

What it if "SLIPS" while the system is in use, now you have an out of service client.

After all, a back plane is so darn inexpensive.

http://home.comcast.net/~merlinman

 

[Pepperz]

That's what I needed MM. Thahks, as always. I was concerned there was a more sinister reason (Voltage change??, or something like that)
Always a good source. Thanks again.

 

[dagwoodsystems]

I hate to admit to doing so, but I've actually opened up the power supply and used a pair of criss-crossed zip ties to keep the switch closed (snort laugh). I know, I know...such a cheap guy. But I was in a jam and had to make it work on short notice.

Tim Alberstein

http://www.dagwoodsystems.com

 

[Pepperz]

Didn't Lucent used to put an insertable pin in with the PS ?

 

[cvrbob]

I like Dagwoodsystem, broke 1 while transportation to new location, quick fit was a small head screw, and enlarged the hole, worked great

 

[SYQUEST]

Sometimes, you do what you have to do to make things work for the situation @ hand! And when possible, or the time is available, go back and put in the correct item or for whatever the situation calls.

....JIM....

 

[Pepperz]

With the people here that have been able to "make things work", and keep things running, I'm wondering if there is a need to alter the software for the date change after 2099. ........maybe.