Legend 7.0 pool change 1

[printtek]

How do I change what port a pool uses?
I am trying to configure how 911 dials.
I am using a 10DS1 for all inbound and outbound calls.

 

[2BAvoice]

First step, print ars tables. I am not 100% sure what you mean by "what port a pool uses". I am thinking maybe you mean what pool is used when you dial 911?

 

[printtek]

A TABLE 18: Default Local Output Table

A Pool Absorb Other Digits FRL Call type Start Pattern
A 1)892- 00 -------------------- 2 BOTH --:-- A
A 2)70-- 00 -------------------- 2 BOTH --:-- A
A 3)---- -- -------------------- - BOTH --:-- A
A 4)---- -- -------------------- - BOTH --:-- A
A 5)---- -- -------------------- - BOTH --:-- A
A 6)---- -- -------------------- - BOTH --:-- A

A Pool Absorb Other Digits FRL Call type Start Pattern
A 1)70-- 00 -------------------- 3 BOTH --:-- B
A 2)---- -- -------------------- - BOTH --:-- B
A 3)---- -- -------------------- - BOTH --:-- B
A 4)---- -- -------------------- - BOTH --:-- B
A 5)---- -- -------------------- - BOTH --:-- B
A 6)---- -- -------------------- - BOTH --:-- B
A AUTOMATIC ROUTE SELECTION



A TABLE 19: Dial 0 Output Table

A Pool Absorb Other Digits FRL Call type Start Pattern
A 1)---- -- -------------------- - ----- --:-- A
A AUTOMATIC ROUTE SELECTION



A TABLE 20: N11 Output Table
A 01)411 02)611 03)811 04)911

A Pool Absorb Other Digits FRL Call type Start Pattern
A 1)70-- 00 911----------------- 3 BOTH --:-- A

 

[merlinman]

The way it is set now, 911 calls will route over the 70 Pool.

How do you want this to work?

 

[printtek]

I would like it to use pool 892.
I would like N11 to use pool 892 as well.
Using WinSPM Quick connect, I cannot change the pool for special numbers.

 

[merlinman]

Nope, you can not, it is always the 780 Pool.

Therefore, you have to put the lines you want to use for that purpose in the 70 pool.