Legato wont see autochanger

[Guest_imported]

Hallo, I'm installing 6.01 on a Compaq ML370 running NT 4.0 with service pack 6a. The library is a StorageTek L700.

After running inquire and jbconfig, the Jukebox was seen at the command prompt and all SCSI id's are correct (changer being 0).

The problem is that the Autochanger is not seen within the Networker Administrator. However, all the drives are.

Originaly, the SCSI id for the changer was set to 6 with the drives at 0 and 1. The changer and the drives are on one bus with another two drives on another bus.

Many thanks in advance for any ideas

 

[Voyager1]

Delete the autochanger and all of the devices from Networker Admin. Make sure there are no tape drives left. Then run jbconfig again, choosing the "autodetect" option.

This has worked for me before... - Bill

"You can get anything you want out of life, if you'll just help enough other people get what they want" - Zig Ziglar