Least cost routing

[mikeyb123]

Hi,

I have least cost routing on one of our md110's what commands can I use to print what is happening? I seem to be routing via 2 different providers.

Sorry if this is a simple question but my main skillset is meridian, and if there's anything above printing phones ona md i'm stuck.....

Thanks for the help.

It's not getting any smarter out there. You have to come to terms with stupidity, and make it work for you.

 

[snakeblitsen]

Hi,
Do NADAP:NUMTYP=LC;
This will show which numbers are subjected to LCR.

Do LCDDP:TAB=ENT;
These numbers are translated and pumped straight back into the system.
Do LCDDP:TAB=DNT1;
This is the exceptions table, FRCT gives a number which in the FDT table is allocated a new destination code. This DEST code is programmed as normal to a Route.
Do LCDDP:TAB=DNT2;
This gives the non-exceptions FRCT's.
eg in table DNT2 you could have
912
913
914
but in the DNT1 table you could have
9123 which would give a different routing as 912.

Do LCDDP:TAB=FDT;
This shows which destination codes are allocated to the FRCT's
It is pretty smart, if you know what you are doing you can make your system 'dance'.
Cheers