ld 60 - T1 circuits

[coniglio]

what does VOD mean next to the channels in a T1? if it means Voice Or Data, can i take some of those channels and use them for data? i was told only a data circuit can be provisioned for voice as well but a voice circuit cannot be provisioned for data too. Please clarify. And what does 3VCE mean next to a channel? 3 what? thanks

 

[one234]

Hi,

- VOD -> Voice Or Data

- DTA -> Data-Only route

- VCE -> Voice-Only route

- 3VCE -> Voice route and 3.1kHz

- 3DTA -> Data route and 3.1kHz

Marc D.

No trees were killed in the sending of this message. However a large number of electrons were terribly inconvenienced.

 

[coniglio]

Great. But i still don't know if I can use channels from my VOD circuit for data as well.

 

[Reusser]

Both these prompts are programmed in the route under the prompt DSEL

VOD = voice or data (however, this is the data from the switch or for things that are built on the digital card ports 16 through 31)

3VCE = voice route and 3.1khz - this is my primary choice for today as it matches what most CO are using today

 

[one234]

VOD trunk you can use Voice and Data, but not at the same time... So a call is Voice OR Data..

Marc D.

No trees were killed in the sending of this message. However a large number of electrons were terribly inconvenienced.

 

[coniglio]

not that i know what 3.1khz means, but thanks for the explanation. Perhaps something is off on my programming vs. AT&Ts programming and thats why my counters are off (whatever "counters" are). thanks again.