ld 60 counters

[coniglio]

waht does the below actually mean?

DTI TRK LOOP 9
TRSH CNT:
BPV -000
SLIPD -394
SLIPR -000
CRC -000
LOSFA -000
OS_BPV -000
OS_LOSFA-000
OS_YEL -000


The SLIPD parameters are always off when i do an LCNT. This has been happening for three days. The T1 card & CSU have been replaced. AT&T has done whatever they do test-wise and this still happens. I have a vendor meet between AT&T & Bell SOuth this afternoon because the T1 keeps dropping. anyone have any suggestions? thank you

 

[gbriggs]

I have found this to be in the x-conn. I would replace from D-Mark to Equiptment. Problem is most likely in the street x-conn. If you look in the X11 Maintenance NTP under LD60 in the alphabetical list of commands there is a discription of this area in question.

 

[phonedoc]

your clocking is wrong. if you are clocking from this span then AT&T are not sending you clocking.

 

[kcfonman]

Check to make sure your clock is not in free run. Go to LD 60 and type SSCK 0. You should see lock to slot. If not type TRCK PCK to track on the primary clock.

 

[coniglio]

after an eight hour conference call this past Saturday (yes, Saturday!) it was determined that the PBX clock controller card was defective. we replaced it and no more slips. Thank you for your help.