LCR Time of Day, Help!

[rightsaidfred]

Hi!

Could you describer how LCR Time of day works?
For Example I´d like to program the following:

On weekdays after 6pm calls starting with: 0 0630... should go to another route, which dest is: 26. So number should look like: 260630.

Thanks!

 

[lancbomb]

LCTDP;

LCTDIAY=M-F,TIM1=08-00,FDT1=2,TIM2=17-00,FDT2=6,
TIM3=20-00,FDT3=9;

where "The day group MONDAY to FRIDAY shall be divided into three time intervals viz. 08:00-16:59, 17:00-19:59 and 20:00-07:59. The FDT-entries for the different intervals shall be 2, 6 and 9 respectively"

FDT is fictious route table, found by printing

LCDDP:TAB=FDT;

HTH

LB

 

[rightsaidfred]

Thanks Lancbomb,

Could you give an example? Please!

 

[lancbomb]

I just did

 

[lalrl]

A complete example will consist of at least 10 commands or more, depending on the fact, whether or not LCR is already activ in your system? Is it?

 

[rightsaidfred]

Yes, I use LCR.

 

[rfpui]

To be sure that the Time of the Day can be used check
CNPIP:UNIT=LRP4;
If this program unit is loaded in system, Time of the day can be used, if no Time of the day is not available.

 

[rightsaidfred]

Yes, loaded.

 

[lancbomb]

RFPUI,
if the unit is not loaded, can you still do the commands ?

 

[rfpui]

hi lancbomb
Commands LCTDx (x=P or I) will be as command unknown
LCDDI:TAB=FDT parameter TZONE is not available.

Have you Alex?

BR

 

[lancbomb]

cheers
and yes

 

[rightsaidfred]

So, how is it?