LCR -Dial tone

[trond456]

Hi,
I have the following scenario of LCR, the case is that after dialling 9 (LCR digit) users will not hear dial tone based on ASPAPARNUM=104;(not to send dial tone)... users will complete dialling after 9, for example 07, after the third digit users will hear the dial tone....

What I'm trying to do is to hear one dial tone just after 9(lC digit), and not after seizing the truk... could this be done?!
I have already tried to change with the first digit of SIG in ROCAI (0,1,3,4,5).. but always I hear the dial tone after seizing the trunk....

If we use ASPAC:APRNUM=104, PARVAL=1; I will hear two dial tones one after the LC digit 9, and the other after seizing the trunk (07)

ROCAP:ROU=1;ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
1 0110000001000010 4 3110000000 0 30 128 00151515 000100000000 001100

END

<RODAP:ROU=1;ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
1 TL11 H'0000A021 H'00000708 H'0000A015 NO

END

<RODDPEST=ALL;EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
8 1 0005000000000250000000000 0 2 0

Is ther any advice....

 

[trond456]

Any news??

 

[mundus]

If you have EOS on the outgoing trunk, then set the SIG d8 to 2, or use the NLT table with MIN and MAX.

 

[trond456]

Thank you... your post solved the problem