CallwaveEmp
Technical User
- Aug 30, 2002
- 106
I have an 8 sequence backup that is 1 single session. I am attempting to do a test restore, and I am getting an EX8522 (Timeout waiting...) Arcserve 2k, SP4, with the hardware patches.
As near as I can figure out, becuase this is only 1 session, Arcserve does not know exactly which tape to load - so it is scanning every tape. However, the first thing Arcserve does is connect to the client agent - therefore, by the time it has found my files, tcp has timed out.
I have followed the doc at
( I am waiting to see if this works)
but, I see this as an architectural issue/design flaw. As my data grows, I can't just keep growing my tcp timeouts.
Discussion anyone?
As near as I can figure out, becuase this is only 1 session, Arcserve does not know exactly which tape to load - so it is scanning every tape. However, the first thing Arcserve does is connect to the client agent - therefore, by the time it has found my files, tcp has timed out.
I have followed the doc at
( I am waiting to see if this works)
but, I see this as an architectural issue/design flaw. As my data grows, I can't just keep growing my tcp timeouts.
Discussion anyone?