I just tried using labels on my 850 for the first time. The first two pages I tried to print resulted in a jam from the label sheet not feeding through all the way (from manual feed). The labels didn't come off the page or anything like that, seems like maybe the sheet was either too thick or the backing was too slick.
The third attempt was OK, but my question now is - is it OK to use labels in the manual feeder and/or the paper tray? I do not see a setting through the front panel or the driver to set it for labels.
In fact, I don't see any kind of paper setting other than for transpaerency. Does this printer not require different settings for paper/labels/envelopes/etc.?
The third attempt was OK, but my question now is - is it OK to use labels in the manual feeder and/or the paper tray? I do not see a setting through the front panel or the driver to set it for labels.
In fact, I don't see any kind of paper setting other than for transpaerency. Does this printer not require different settings for paper/labels/envelopes/etc.?
