Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

LAB trying to turn up FXO FXS

Status
Not open for further replies.

KodiakAK

Vendor
Mar 30, 2011
23
US
I have 2 1760s with [2] vic 2FXO cards in one and [2] vicFXS cards in the other. How do I enable the cards so I can see them in show run?
 
do you have any PVDM's in the router?
a show diag will tell you if you do.
If not then you need to add PVDM's to enable the VWICS.
 
OK, I went through my stack of old gear and found one with a Packet Voice DSP Module.

I put an FXO in slot 0 and an FXS in slot 1, show run and


boot-start-marker
boot-end-marker
!
!
no aaa new-model
voice-card 0
!
voice-card 1
!
ip cef


very excited.


The first thing I would like to do is plumb an analog line into the FXO and have it pop out the FXS. I am pretty sure this is possible.

I do not understand any of the commands, but I do have experience on Mitel and Nortel PBXs could I please beg for a snippet of config to get me started.

for starters, I do not understand how dial-peer relates to the voice ports. do I have to assign the same dial peer to both the IN and the OUT port on the FX cards?

After this, I am going to try to find another router that can support my equipment and attempt to extend an analog line through two networked routers. Eventually I would like to get 5 lines, but I dont think the 1700 routers can support that.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top