I am trying to set up a Lab (CCNA) using the following equipment.
1. 3640 as an Access/Terminal Server ( I will connect to this via console, I won't access via network)
2. Two 2600 series Router
3. One 2800 series Router
4. Another 3600 router
5. 3 Catalyst switches 12 Port, two 48 Ports.
The first thing I want to do is configure the 3640 Access server, what configuration can I use for this router. I have just been able to find configurations using the 2500 series routers as a jump servers.
I have an 8 lead Octal cable with HD68 to (8) RJ45 connector ends. This will connect from the 3640 to the other devices console ports (cable will connect from ASYNC module interface 0-7 on the 3640).
I have WIC 1T & 2T cards and correct cables for all the other routers to connect to each other. I want to first get the terminal server going. Any help with the correct configs would be appreciated or a link to configs for the 3640 access router.
1. 3640 as an Access/Terminal Server ( I will connect to this via console, I won't access via network)
2. Two 2600 series Router
3. One 2800 series Router
4. Another 3600 router
5. 3 Catalyst switches 12 Port, two 48 Ports.
The first thing I want to do is configure the 3640 Access server, what configuration can I use for this router. I have just been able to find configurations using the 2500 series routers as a jump servers.
I have an 8 lead Octal cable with HD68 to (8) RJ45 connector ends. This will connect from the 3640 to the other devices console ports (cable will connect from ASYNC module interface 0-7 on the 3640).
I have WIC 1T & 2T cards and correct cables for all the other routers to connect to each other. I want to first get the terminal server going. Any help with the correct configs would be appreciated or a link to configs for the 3640 access router.