KXTD 1232 ISDN

[TwoWitnesses]

I have a KXTD 1232 with a BRI unit in slot 1 then two 8 extension units. I have looked at CMD 109 : Mast.:s;s ;E1;E2
Is this correct. Are my ISDN port numbers 03,04,05,06 and if so what trunk numbers will they be. I have tried to put trunk or co numbers 03-06 in TKG1 but the system says no CO assigned. I have a manual but...............

Thanks in advance.

 

[cwc3]

which card do you have 384 or 386 09 ,10 ,11, 12 1-8 are loop co's do you have the ground screw in the card? did you reset the system after installing the card spids an dn
in there properly

 

[TwoWitnesses]

Thanks for your reply. My ISDN BRI module fits on outside and is a 280. When I try and go to the to codes for SPID and DN 453 and 454 the system is telling me its TIE transfer and TIE to CO?

 

[cwc3]

are you in europe?we dont have a 280 here and are you using
dos or windows for programing software?go to

http://www.pbxinfo.com

panasonic forum ,there is a bloke from ireland and uk there that knows the bri stuff off the the top of there head bri never caught on in the usa i actually have my student study guide from back in 99 handy but i fear your isdn programing is not the same here!

 

[TwoWitnesses]

OK I'll give that a try. Thanks for your time.