KX-TDE100 Setting Up DID on CO Line

[jja776]

I am trying to set one of my CO lines on an LCOT16 card for DID mode on my KX-TDE100. When I go into DIL Table & Port Settings and try to change the Distribution Method to DID, I get "E000501 Invalid parameter (combination error)". I've tried looking around to figure out what is preventing me from changing the line to DID, but I don't know why. Can someone please tell me how to set up DID on this system? Thanks!

 

[omonat]

I thought Direct Inbound Dialing (DID) is supported only on ISDN lines
Can someone correct me?

 

[jja776]

I wondered if it was constrained to ISDN and/or T1 ports. I don't see anything about that in any of the manuals. Due to their length, I could certainly be missing it.

 

[WhiteGooner]

DDI's are only available on ISDN or SIP.

Standard analogue trunks can only be routed per line.

 

[jja776]

Thanks for clearing that up!