I am unable to get my CSIF8 card working in a KX-TDE600 chassis. When I try to put it in service I get a "Card Obstacle" error. The card is recognized and the diagnostic runs fine, but it won't let me put it in service. I tried a system initialize, and no change.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
KX-TDE and CSIF8 problem
- Thread starter jstjohn
- Start date
obtsystems
Programmer
have you connected a cell station to the first port on the card first
- Thread starter
- #3
I have a cell station on port 1. I don't remember the specific order, as far as card insertion or cell station connection. I know that at one point I had the red LED lit on the cell station, then it went off.
I can't find any reference to a "Card Obstacle" error message in the documentation. Is it possibly a firmware version issue on the CSIF card?
I can't find any reference to a "Card Obstacle" error message in the documentation. Is it possibly a firmware version issue on the CSIF card?
obtsystems
Programmer
Card obstacle is if you have a faulty card or could be there was a different card in the slot first and not deleted. What version is the system. What slot is it in
- Thread starter
- #5
I think you got it. I deleted the card using the maintenance console, then installed it using maintenance console. At that point it was showing status of "Pre-Install". Then I unplugged the card, waited a few seconds, and plugged it back in. Then status went to INS. So basically I think it's my ignorance of the sequence that needs to be followed. Learning as I go, and thanks for the help.
- Status
Similar threads