KX-T 61610CE Call restriction (international)

[Lehrer]

Hi,
Is it possible to apply Call restriction (international)on KX-T61610CE.??
Thanks

 

[Lehrer]

I set ext16 class 3 but no effect was occur!! The system has only 3 classes.

 

[cwc3]

get a toll restrictor on the lines

 

[bigglesnz11]

have you entered the toll restriction codes against the class of service?

 

[Lehrer]

Sorry, i see this system for first time

1.What is the toll restriction codes(what command)??

2.Toll restrictor??

Thanks.

 

[cwc3]

read the book!!

 

[bigglesnz11]

If you only have 3 classes, I assume you set this via command 11, if so then you select the area codes to deny in command 12, if you have set class 3 then it will deny all codes in locations 00-09

 

[Lehrer]

For Dial(12)--Toll restriction Area code selection.
In book writes that all area codes except those entered here will be denied, but this can not be done!!

 

[cwc3]

maybe your system no longer can support your numbering plan...

 

[bigglesnz11]

My manual says:
"Area codes programmed will be denied. All extensions programmed for Service Class Selections shall be assigned to the same area code selection plan. Memory locations 00~04 are effective to class 2 and 3, Memory locations 05~09 are effective to only class 3

 

[YuryPetrov]

But my manual says about 12 code:
"Memory locations 00~09 are effective to class 2 and 3, Memory locations 10~19 are effective to only class 3

 

[cwc3]

you need a new system

 

[bigglesnz11]

Yuripetrov, you must have a -2 switch or later