KX-NT136 external ringer

[KenMeans]

Anyone know of a good way to setup A loud ringer for a KX-NT136 IP phone ?

With out spending $400.00

Ken Means

http://www.tel-is.com

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)

 

[obtsystems]

what system do you have...

 

[KenMeans]

The TDA50 but the box is at one location and the IP phones are down the road a ways. So I need a loud ring indicator for the IP phone itself

Ken Means

http://www.tel-is.com

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)

 

[obtsystems]

If you have a spare analogue port you could use a Cisco ata with a fxo and another one with fxs port on each end and plug the extension in at system end and the other end can have a bell. Put the phone in a group and the will both ring

The spa 3102 on each end programmed to pass fxo to the fxs would work

 

[KenMeans]

I don't have any analog on the system

Has anyone taken the speaker on the phone and wire it to a Valcom speaker ?


Ken Means

http://www.tel-is.com

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)