Hello colleages,
I have to setup an networking key system group.
I already found out i have to setup an community.
But im not sure how its done. Speko is set to 2.
Somewhere on this forum i read about reporting paths.
How do I set this up? Im not at work right now, but if im
Correct we are running on sw version 8.
Can somebody point me in the right direction?
With regards,
Robert
I have to setup an networking key system group.
I already found out i have to setup an community.
But im not sure how its done. Speko is set to 2.
Somewhere on this forum i read about reporting paths.
How do I set this up? Im not at work right now, but if im
Correct we are running on sw version 8.
Can somebody point me in the right direction?
With regards,
Robert