I'm adding a kem to a i1140e have programmed buttons but nothing is showing up on
kem other than i00v142 v115
I have kem 1 and kem3 programmed in software
Upon reading other responses to this issue it sounded like a power supply is only needed if
a back light is wanted, so I should be able to see the buttons.
Thankyou for any help
extreme10
kem other than i00v142 v115
I have kem 1 and kem3 programmed in software
Upon reading other responses to this issue it sounded like a power supply is only needed if
a back light is wanted, so I should be able to see the buttons.
Thankyou for any help
extreme10
