Just Want to Reseat CMDU NT5D61 1

[Telco01]

I just want to reseat the CMDU before I get a replacement. Have seen this clear up problems before. The good CPU is in MAINT mode. Just can't remember, do I need to faceplate disable the CNI's in the inactive CPU before doing the sequence below?


LD 137
STAT (STATUS OF IODU/Cs)
DIS CMDU x (disable suspect CMDU)
DIS IOP x (disable suspect IOP)
Set ENB/DIS switch to DIS
Remove NT5D61 IODU card
Reinsert NT5D61 IODU card
Set ENB/DIS switch to ENB
ENL CMDU x
ENL IOP x
STAT

This is my problem:

OVL000
>ld 137
CIOD000
.stat
IOP 0 ENABLED (STANDBY: S/W STATUS) IODUC
IOP 1 ENABLED (ACTIVE) IODUC
CMDU 0 DISABLED (No Access to HDK)
CMDU 1 ENABLED (ACTIVE)
RDUN DISABLED
ELNK ENABLED
SDEV 1 OK (KC VALID)

 

[bigindian65]

I would. I would make sue I was properly split first prior to that and come out of maint when the sys 700 mess appears.

Mato' Was'aka

 

[phonz1]

run the test on the HDK, sometimes that will bring it up, otherwise no need to dsbl the CNI's, just faceplate dsbl the cmdu and reseat it

 

[Triton101]

Try a DATA cmdu 0 hdk as suggested above and try a SYNC after.....


__________________________________________________________
Find a job you love and you'll never work a day in your life. - Confucius

 

[tnphoneman]

If this IODU/C is release 4 or 6 toss it ang get a new one. There is a known problem with them doing this exact thing.

Signature===========================================
Artificial Intelligence Is No Match for Natural Stupidity.

The latest survey shows that 3 out of 4 people make up 75% of the population.

The original point and click interface was a Smith & Wesson.

Red meat is not bad for you, it is the green fuzzy meat that is bad.

 

[Telco01]

Mission accomplished without and disruption. I did not disable the CNI's. Reseated CMDU, enabled and did SYNC. Everything tested and did SCPU. A-OK.

Thanx

 

[GHTROUT]

Good work. I just disable the CMDU, throw the switch and pull it out. no need for any fancy work.

GHTROUT.com | FAQs | Recent Replies