Just posted needle gauge component in FAQ 1

[djjd47130]

I just posted my needle gauge project in the FAQ section of this forum:

http://tek-tips.com/faqs.cfm?fid=7512

It's been quite some work to get it to where it is now, and I thought I'd share my progress with it. It's in good working condition, but still has a lot of missing pieces (as far as my future plans with it).


JD Solutions

 

[djjd47130]

Well, somehow tek-tips decided my source code was too large, and somewhere along the line truncated it.

Apologies.

JD Solutions

 

[Glenn9999]

No problem. I wondered often if there was a text limit and how cautious I needed to be about posting certain things. Now I know.

It is not possible for anyone to acknowledge truth when their salary depends on them not doing it.

 

[djjd47130]

And it was short by only about 20 lines... I can cut a lot of that outta there and clean it up...

JD Solutions

 

[djjd47130]

Fixed. There was a lot of old unneeded commented out code, plus some unnecessary line breaks.

JD Solutions