Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

jpeg shinks/crops 1

Status
Not open for further replies.

officemanager2

Technical User
Oct 11, 2007
116
CA
Hello: I'm new to Corel Draw X3. I have created a document which I then export to JPEG. The problem is the borders of the final jpeg are too tight. I've done the page set up at 4" by 1" (it's a logo) but when I export to jpeg the borders sinch in and the logo looks like it's been cropped? Ideally I'd like this image as a jpeg, but perhaps in another format this problem would not occur?
 
I'm guessing that the objects on your page do not extend to the edge of the page on the side(s) where the cropping is occurring.

Corel usually creates bit images whose size is determined by the objects rather than the design page size, but there is a simple way to force it to the page size.

Layout : Page Setup : Add Page Frame will create a rectangle that's the full size of your page.
Give that object a solid white fill and no outline, arrange it to back so it doesn't hide your logo. Then either select all or select nothing, and export.

The result should now be an image that is the full page size including any margins.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top