No error, job just sits in the queue in ready state. If I submit the job manually to run right away, it runs fine. This is ARCserve 11 for Windows. Had this situation in ARCserve 7 for Netware (solution was 'concurrent jobs =')any number greater than 0. Nothing in Brightstore knowledgbase about this problem.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Job will not start after submission with scheduler
- Thread starter rickoval
- Start date
Have you tried to stop and restart the Arcserve services?
Did you try to set the time to an earlier start time than the current time? If yes, does it still just sit in a ready state?
The most usual problem when your backup job is not starting is a job configuration problem.
Check your backup job, make sure the destination tab is correct (meaning your correct SDLT or DLT is selected)
Hope it helps.
Cheers
GSC
Did you try to set the time to an earlier start time than the current time? If yes, does it still just sit in a ready state?
The most usual problem when your backup job is not starting is a job configuration problem.
Check your backup job, make sure the destination tab is correct (meaning your correct SDLT or DLT is selected)
Hope it helps.
Cheers
GSC
- Status
Similar threads
