Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

issue with category description when using an alternative source file

Status
Not open for further replies.

cologne

MIS
Feb 16, 2009
1
DE
Hello,

In Transformer 6.61 we have a structure file for the category “cost category”.

For one and the same category exists two translations separated by two different structure .imr files in Impromptu. The first structure file is the main source file in our transformer model. The second we use as an alternative source file, when we build a second Powercube within the same transformer model for another plant in another country.

When the powercubes is built, the measures were found from the table of facts – which is defined as an alternative Source file, too - , but the translation of our “cost category” is always the translation of the main structure source file, if the “cost category” exists here. Only if it doesn’t exists there, Transformer takes the description from the alternative source file.
We have thought, that cognos access only to the alternative source files, if they are defined.

Is this a misunderstanding?

Thanks for a little help / advice
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top