ISDN Tandem Call - CLI

[bsmo]

Hello,

How can I define which CLI goes out on a trunk to trunk call using the same ISDN trunk (PRI) ?

Bram

 

[bsmo]

Nobody ?

 

[definityandcmuk]

depending on your software have a look at

"change isdn public-unknown-numbering"
or
"public-unknown-numbering"

You can specify your outgoing CLI on this page. You need to check your trunk group settings (page 2) as well

http://support.avaya.com/elmodocs2/comm_mgr/r3/pdfs/03_300509_1.pdf

go to page 1318 in the above document, it will give you all the information you need

 

[bsmo]

definityandcmuk,

This is working for 'normal' outgoing calls but doesn't seem to affect the tandem calls.

 

[definityandcmuk]

have a look at page 1150 of the admin document there is a command "change tandem-calling-party-number" screen which may help

 

[bsmo]

definityandcmuk,

Maybe my question is not clear. I want to do the following:
Call comes in on a DID number and goes directly out again using the same trunk to a mobile. I want to send a specific CLI to the mobile no matter what the CLI of the incoming caller is.

Has anyone an example how to do this ?

 

[Doyaya]

If you have CM2 there is command change tandem-calling-party-num. In this table you can change CLI for your case. Also, in trunk group you have to set field Modify tandem calling namber to yes.