Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ISDN Line Setup

Status
Not open for further replies.

mdolhon

IS-IT--Management
Jul 24, 2002
9
US
When we bought our Meridian 1 Option 11C system, we had the ability for 6 ISDN lines put into the system, yet it was never needed...until now. Now we have a very urgent need for it (as in it needs to be up and running yesterday) and it appears as though the cards (MISP & UILC) were never setup, enabled, etc. I have found in the manual how to set this all up, but I am unsure how to check if the lines are even active, how to assign them a number, etc. Any information on this and how to setup the MISP and ULIC cards from scratch (and any other settings that go along with them) would be appreciated.
 
going from memory
ld 27
req=prt
type=tsp or dsl

you also do changes in the same overlay
Colin
 
LD 32 is where you enable, disable and stat MISP and ULIC cards.

If you have the networking BRI book - there is a great section that gives you examples - this includes all programming and testing.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top