Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

isdn basic rate

Status
Not open for further replies.

gameoflife

IS-IT--Management
Mar 24, 2008
23
GB
can you change the basic rate circuits on a ipx office from st to te
i am having issues with a video conf seeing the circuits !!
 
Yep. Easily done. Go to DTDB,4,1 and change PROTOCOL_SIDE from User to Network.

From the PI Manual:
"Defines the DSL side at the particular exchange as the User (slave) or Network
(master) side. (A DSL must always have one exchange side defined as User while
the other side is defined as Network.) The Network side resumes call control in
restart (protocol failure) situations. In glare situations, Network side calls take
priority over User side calls.
The PSTN (i.e. any public network) is always defined as the Network side, leaving
the Coral system to be defined as the User side.
All ISDN applications (such as Video Conferences) are always defined as User,
thus enabling the Coral system to take charge as the Network side."

And EXTENSION to Yes.

From the PI Manual:
"Defines the Network extension as a port or trunk. Enter Y to connect the BRI line
to an external application or terminal equipment such as Video, Router, ISDN
telephone, etc. Enter No to connect the BRI line to another Coral or another PBX.
thus defining the BRI line as a trunk."

This will get the VC unit working and dialling out. If you want to setup an incoming call to it then it's a bit more involved. I'd need to do some digging but I think it's something like this - put BRI ports in a trunk group, create a Pub.Lib. that dials 1 out on this group, direct the DDI to this Pub.Lib. Something like that anyway.

If you have problems dialling out you made need to check the BCCOS in the COS for these ports.

Hope that helps.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top