Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
is this the valid cross cable setting for 10BaseT and 100BaseT
- Thread starter miq
- Start date
daronwilson
Vendor
You have the data pins correct, but terminate all the wires in the connectors. There is no reason to not connect all four pairs, and several reasons why you should. Just do the other two pairs as you would a straight cable.
Good Luck It is only my opinion, based on my experience and education...I am always willing to learn, educate me!
Daron J. Wilson, RCDD
daron.wilson@lhmorris.com
Good Luck It is only my opinion, based on my experience and education...I am always willing to learn, educate me!
Daron J. Wilson, RCDD
daron.wilson@lhmorris.com
- Thread starter
- #3
- Status
Similar threads
