is there anyone using CISCO1751 for voice???

[zola343]

I'm experimenting voice configuration with CISCO 1751 my IOS is version 12.3(6).

it seems that commands voice-port and dial-peer are not recognised by the router (in configure terminal mode).
when using voice-port I get <<% Invalid input detected at '^' marker>>

(I have installed I VIC FXS card on the slot 2 and I have the leds 'in use' on )

What could be wrong?
I there any hardware activation needed.

here what the boot message of my router:

Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Wed 11-Feb-04 20:25 by kellythw
System Bootstrap, Version 12.2(1r)XE1, RELEASE SOFTWARE (fc1)
TAC Support:

http://www.cisco.com/cgi-bin/ibld/view.pl?i=support

Copyright (c) 2001 by cisco Systems, Inc.
C1700 platform with 65536 Kbytes of main memory
Cisco Internetwork Operating System Software
IOS (tm) C1700 Software (C1700-IPBASE-M), Version 12.3(6), RELEASE SOFTWARE (fc3)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Wed 11-Feb-04 20:25 by kellythw
Image text-base: 0x80008120, data-base: 0x80C73660

Cisco Internetwork Operating System Software
IOS (tm) C1700 Software (C1700-IPBASE-M), Version 12.3(6), RELEASE SOFTWARE (fc3)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Wed 11-Feb-04 20:25 by kellythw
Image text-base: 0x80008120, data-base: 0x80C73660

cisco 1751-V (MPC860P) processor (revision 0x300) with 52429K/13107K bytes of memory.
Processor board ID FOC08077DMQ (163514908), with hardware revision 0000
MPC860P processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
1 FastEthernet/IEEE 802.3 interface(s)
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)

 

[ccmuser]

Sound like you need an IOS upgrade.

Do you have the pdvm's ?

 

[thebruge]

I'd say you need to upgrade your IOS featureset from "IP BASE" to IP VOICE of IP VOICE PLUS.