Is there a way to see IP addresses in "show access-list"

[bugskumar]

If the PIX config uses names to IP address mappings, when you do a "show access-list" command, it shows the name in the output and not the IP address of the source or destination object.

Is there a command or way to see the actual IP address (and not names) in the output?

Thanks

 

[bobbyforhire]

no name 10.0.5.1 VPN
no name 10.3.0.0 INSIDE
Run the report and put back in the names....if you want.

If that doesn't do it for you try
no nameif ethernet0 outside security0
no nameif ethernet1 inside security100

I personally have not tried this but would like to know what would happen if you did put that in would it remove the security level??? If you do, make sure it's after hours