I wanted to know if there is a command to list every port that shows status disconnect? we have 8720's running CM 3.1 with about 2500 stations. I know there's extensions assigned to ports that don't have anything connected on the other end. Currently to do clean up, I have been doing "disp port xxxx" followed by "stat station xxxxx" to see if it's active/idle or disconnect state. Any info would be greatly appreciated. Thanks,
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
is it possible to list disconnected sets?
- Thread starter adrok78
- Start date
Do 'display alarms' and look for the ports with warnings and a Service State of 'RDY'. The 'Alternate Name' field shows the extension number assigned to the port. Analog ports that have the 'tests' field set to 'n' on the station form will not show up.
Kevin
Kevin
steeltown89
MIS
disp errors
Put in 513 for error type, this will tell you all the disconnected sets and the types (analog or digital).
Put in 513 for error type, this will tell you all the disconnected sets and the types (analog or digital).
- Thread starter
- #4
Thanks!- Status
Similar threads
- Locked
- Question