IPSI problem

[TheCurious]

Hi people,

I have a problem during an installation, S8710, 2xG650, one IPSI.
Something strange happens between S8710s and IPSI.....

List IPSI
Serv state: OUT
Control state: active
state of health C P E G: 0 1 1 0

List config all - does not find any boards in G650...

I can ping server from IPSI, and IPSI from server.
I can telnet to server from IPSI.

Any ideas ?

The Curious

 

[rjblanch]

What we had to do is go through all of the steps, like test board, test IPserver, change data switch ports and cables, before Avaya would believe it was a faulty card.

There are some really good tests and checks in the Maintenance manual, available from the avaya site.

 

[TheCurious]

I have changed the IPSI
I have done NVRAM INIT on the switch, and did all the switch settings again
I have changed terminators on the backplane of G650
I have installed Communication Manager again
I checked all the cables

No success at all....



The Curious

 

[charmstrong]

Hi,

Have you done a change system-parmameters ipserver-interface?

 

[TheCurious]

Yes, I have done that (IPSI is enabled)

The Curious

 

[qz01gs]

what happens when you telnet on to ipsi and reset it?

maybe get avaya to check the logs and see what they say

 

[h5n1]

check 'change circuit-pack' it might recongize it as a tone-clock only....might have to manually remove it and put in the ipsi card there to get it up...

 

[tbg247]

What is your IPSI speed/duplex setting? What's your network switch speed/duplex?

 

[TheCurious]

Hi people,

Problem is solved. Both of control networks were on the same subnet. When I removed control network B, IPSI became operable.
Stupid, but this is my first S87xx installation....

Thanks,

The Curious