chrisrudeau
Technical User
Hello all,
I'm having a problem getting some IPSEC tunnels up. Basicly I setup HQ 1010 as an initiator and use BOQS on the remote contivity 1050's.
At HQ we have a sprint 645 modem in bridge mode. We have 4 static sprint IP's. So the 645 is plugged into a cisco 12 port switch. The 1010 is plugged into this configured with a static wan ip. If I plug a 1050 into this switch and configure a 1050 with a different static IP, run BOQS the IP tunnel comes up and evertyhing works.
When I go home and run BOQS on another 1050, the IPsec tunnel comes up but that is it. I can't ping any of the HQ machines. But I can't howeever manual assign an IP to my phone or latop that is on the HQ network. Tells me there is an IP address conflict.
At my house I have the contivity 1050 plugged into my linksys router. I'm pretty sure that everything is setup correctly, but I'm having a routing issue. Looks to me as nothing is telling the contivity to add the 192.168.2.0 network as a route.
Any ideas???? The main reason I don't have the contivity in front of the linksys is because these boxes were free to use (the 1050's) and all that the are for is the I2050 ip phones.
I'm having a problem getting some IPSEC tunnels up. Basicly I setup HQ 1010 as an initiator and use BOQS on the remote contivity 1050's.
At HQ we have a sprint 645 modem in bridge mode. We have 4 static sprint IP's. So the 645 is plugged into a cisco 12 port switch. The 1010 is plugged into this configured with a static wan ip. If I plug a 1050 into this switch and configure a 1050 with a different static IP, run BOQS the IP tunnel comes up and evertyhing works.
When I go home and run BOQS on another 1050, the IPsec tunnel comes up but that is it. I can't ping any of the HQ machines. But I can't howeever manual assign an IP to my phone or latop that is on the HQ network. Tells me there is an IP address conflict.
At my house I have the contivity 1050 plugged into my linksys router. I'm pretty sure that everything is setup correctly, but I'm having a routing issue. Looks to me as nothing is telling the contivity to add the 192.168.2.0 network as a route.
Any ideas???? The main reason I don't have the contivity in front of the linksys is because these boxes were free to use (the 1050's) and all that the are for is the I2050 ip phones.
