Ipoffice 500 with GSM

[tecnimiguel]

good afternoon,
I would like to implement a solution in the office, someone can help me?
We have a Ipoffice 500 partner version ...
And I want to connect a gsm module of Nokia TFE-2.
How can I do?
How do I set up ipoffice for all mobile phone calls output, can go through this module gsm?
Someone can help me?


Configuration

IP500 - 5(22)
DIGITA8/ATM4
PHONE2
VCM32/BRI4

 

[Telecomboy]

You can plug the GSM into an open ATM4 port. Then program that line onto each phone. To use the GSM, you would go off-hook on that line/button on the phone. Unfortunately, the IPO isn't going to be able to route calls based on whether it is a cell phone or not. The IPO has no idea what numbers are cell and what numbers are land-lines.

 

[AndrePa]

Yes, the GSM will work on the ATM4. I setup one up like a Year ago at a site.
I set up trunk for that line, and added trunk apearnce on the phones they wanted cell link on.
I created a new ARS group, so if the cell was on the GSM module it would call out on it. ARS backup for that trunk was pri, so if cell was not present, they could still make a call.

 

[ipohead]

I am not sure where you are but in the UK all mobiles are prefixed with 07 so you can set the necessary route

http://en.wikipedia.org/wiki/List_of_dialling_codes_in_the_United_Kingdom

Is this similar elsewhere?

I'm not sure if all mobile providers like you using GSM modules.

 

[7deedtz]

Plug your GSM onto any ATM4 port, and use LCR for your outgoing calls.
BEST practice though get a BP to do the job or get trained

Mitel, Avaya, NEC, INDEX

http://www.vcs-sa.co.za