makemetrend
Technical User
Hi guys, how do i set up an auth code in IPO11? Thanks in advance!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
IPO11 Auth codes
- Thread starter makemetrend
- Start date
- Status
Create auth codes and set the option 'auth code required' in the used short code.
Need some help with IP Office? CLI based cale blocking: SCN fallback over PSTN:
Need some help with IP Office? CLI based cale blocking: SCN fallback over PSTN:
- Thread starter
- #3
makemetrend
Technical User
Hi derfloh, am i going to change the feature: Dial in our shortcode 9N and changed it to auth code?
Within the short code (dial) you have a checkbox that an auth code is needed to use that short code.
Need some help with IP Office? CLI based cale blocking: SCN fallback over PSTN:
Need some help with IP Office? CLI based cale blocking: SCN fallback over PSTN:
- Thread starter
- #5
Sure
Need some help with IP Office? CLI based cale blocking: SCN fallback over PSTN:
Need some help with IP Office? CLI based cale blocking: SCN fallback over PSTN:
- Thread starter
- #7
makemetrend
Technical User
Hi derfloh, once this programmed. Everytime they dial outside it will ask a auth code?
- Thread starter
- #9
- Thread starter
- #10
makemetrend
Technical User
Auth codes are not working. Once they dial for example 90915XXXXXXX it will beep then once they enter their auth code its not working. Theyre using J129 Phones
- Status