IPO to Definity G3 over a T1

[cwakeman]

This is my first post on this board, so take it easy on me!
I am fairly new to t1 connections and I am trying to connect these two systems in the shop for testing. The IPO is a IP403 ver3 software with the internal t1 card and the G3 I (small system) is ver 6 with aTN767E and a 120A1 CSU module
First of all, is this the right combination of hardware to get this working, if not, what do I need?
I need to know how I should configure both systems so I can call back and forth across the t1.
Thanks up front to anyone that can help.
Ok let the games begin!

 

[supertech2000]

If you haven't done so, set the trunk groups up in both systems including access codes. Connect the systems by crossing the transmit and receive pairs. Transmit tip to receive tip, and transmit ring to receive ring.

 

[jatsmitty]

word