Hello,
I recently upgraded a R4.x to a R9(new processor and cards). One of the modules is a Combo card and Im using a generic analog cordless on port 7. Since the upgrade, I am not able to make that cordless ring as a coverage station.
Example:
Operator is X-100, and cordless is X-150. When X-100 rings, customer wants to have X-150 ring. I tried Bridged Appearance, Coverage Buttons, and Internal Twinning and I'm sucking air on each. I thought R9 was going to address the issue of analog ringing, etc. Anyway, thanks in advance.
Jim
I recently upgraded a R4.x to a R9(new processor and cards). One of the modules is a Combo card and Im using a generic analog cordless on port 7. Since the upgrade, I am not able to make that cordless ring as a coverage station.
Example:
Operator is X-100, and cordless is X-150. When X-100 rings, customer wants to have X-150 ring. I tried Bridged Appearance, Coverage Buttons, and Internal Twinning and I'm sucking air on each. I thought R9 was going to address the issue of analog ringing, etc. Anyway, thanks in advance.
Jim