Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ipLDK20 Multi Site IP Netowrking

Status
Not open for further replies.

pleskuk

IS-IT--Management
Mar 3, 2008
108
GB
Hello all,

I'm thinking to connect 6 distant offices, each one with its own ipLDK20 system (as there will be 6-7 people on each location and they will need local telco service too) through IP Networking.

All locations will be in the same virtual network (VPN), so I wander if anyone has this kind of challenge, and if it's possible at all to connect all of the 5 X ipLDK20 between each other through IP Networking?

Any suggestion will be helpful. Thanks!

Cheers,
Ivo
 
Dear Sir

I have studied this item/issue hard and made a "How to do list" on VOIP trunk and IP phone.

thread1613-1484626

These description are available here in this forum.

///doktor
 
The other one is here: thread1613-1484637

///doktor
 
hello Doktor, and thanks for your support. I've got through the manuals and they are well explained! Until now i have succeeded implementing SIP trunks and IP phones on quite a few ipLDK systems, but never used IP network feature.

You note that beside VOIBE u'll need VOIU. In my case I'll be using ipLDK20 systems with VOIM card (4 channels). Does it neccesary to add VOIU card (additional 4 ch), or the VOIM will be enough considering the number of users and traffic on each end (3-4 users). Of course beside this every system will have its IP networking license.

Also in the destination MPB IP field I'm little confused. It is clear when u network 2 systems between. But in my case i'm trying to network 5 systems as one. They will be in the same virtual network, so i'm unsure how to acomplish this.

Any hints on this?

Thanks again,
Ivo
 
Destination Mpb feature is mainly used when you have Dect on your systems, Otherwise its not necessary. The Voiu should be in the voim so you are fine with Four channels.The procedure for 5 systems is the same for two you just need to add each systems` numbering plan in pgm 322.

Dial Tone shoul be There
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top