Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ipLDK 50/100 Caller ID problem

Status
Not open for further replies.

mrks1

IS-IT--Management
Feb 21, 2008
20
MK
Hello,

I have ipLDK 100 with analog phone lines CLCOB8 with CIDU8. Just for testing i've set CO Ring Assignment to Station 100 which is LDP-7016D.

When i call from outside i'm getting LINE 01 or LINE 02 but i want to see the number that i'm calling from.

So, is there any setting where i can select LINE number or the phone number to be shown on the display. I've searched in PC Admin but i was not able to find something like that.

Regards,
Nikola
 
PGM 147:
CID mode select: FSK
CID name display: TEL

PGM 114:
CLI Name Display: ON

JLMT//
 
Sorry for the late response but i can't find PGM147 in pcadmin and i can't access it from the master phone.

any ideas?

Regards,
Nikola
 
Operation
When an incoming CO call is received at a CO line board:
1. The CLI information is detected by hardware and is distributed to station.


Condition
1. If an incoming CO call is assigned to multiple SLTs of a same slot, the CO rings are generated sequentially with a 1 second interval on the SLTs; CLI is displayed on the SLT after the first ring.
2. For CLI display on the SLT, a Ring Phase (PGM 182 - FLEX4) more than 4 seconds is recommended.
3. If the ring phase is less than 4 seconds, some of the SLTs will not receive CLI display signal.


Admin Programming
? CID ATTR (PGM 185)


///doktor
 
This means that for incomming calls you will be able to see the callers ID.
PGM 182 - FLEX4 - set to min. 4.

Check your settings in PGM185.
PGM185 BTN 1 - CID Usage -> YES.
PGM185 BTN 2 - CID Name Display -> No (0).
PGM185 BTN 3 - Serial Port Select -> Leave unchanged (0).
PGM185 BTN 4 - CID/CO Line Port Mapping - Leave unchanged (0).
PGM185 BTN 5 - Initialize CID Data -> No
PGM185 BTN 6 - CID type II Usage -No.
PGM185 BTN 7 - Fast CID Mode -> No.

///doktor
 
What delay do you have in CO Ring Assingment..
IF you have 0, change it to 1
Try this..

JLMT//
 
Yes, to need a delay. Also check if you really get the CID message (i.e. the telephone number of the caller). In some countries it is a number of DTMF tones, in other places it is FSK. Check your local PSTN company (Telephone company).

///doktor
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top