Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

iPECS UCP100 Factory Default

Status
Not open for further replies.

dsm600rr

IS-IT--Management
Nov 17, 2015
1,444
US
Hello all,

So I have a UCP100 here to mess with (I have never touched a iPECS PBX - I am an Avaya Guy) and I was trying to follow the manual to facorty default everything, which if I understand correctly was to enable DIP-Switch 4, reboot, put the switch back to off and reboot again.

After doing so, the only lights that are lit are the two (PWR1 / PWR2) so I assume it did something however I still cannot ping the default 10.10.10.2 IP Address.

Suggestions?
 
turn dip switch 4 to on . then reboot it .

once you reboot it give it a few mins and all the lights will flash . once you have done this . see if you can ping it then .

the default connection will be
if all the lights stay solid it has crashed and you will need to get it fixed via a company called multimessage if your in the uk if its under warranty .
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top