Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

iPECS 5.5 CLI outbound on SIP trunks

Status
Not open for further replies.

takeapart88

IS-IT--Management
Jun 29, 2012
7
NZ
I am not sure how to get the system to send the DDI or CLI from a STN when using SIP trunks. It is just showing the pilot number to the called party. It was easy to do on the ISDN CO but SIP looks very different. Your help would be appreciated. Thanks.
 
try to set in PGM133 in ID Individuality the FROM ID and the FROM DISPLAY to Outgoing CLI. I think then the station should send out the CLIP/COLP Table plus the station number like it is for ISDN CO line.
 
The default was set to that and still does not work?
 
do you have verified with a trace (wireshark for example) that the LIK sends the wrong number in the invite message or is it just what the other side sees?
 
Try these settings in PGM133 ID Individuality

From ID: Extension SIP-User-ID-Table
From Display: SYS RULE
P-Asserted-Identity: Extension SIP-User-ID-Table
P-Asserted-Identity Display: SYS RULE
Contact ID: Extension SIP-User-ID-Table
Remote-Party-ID: Extension SIP-User-ID-Table

Jacksonville Florida Telephone Systems
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top