milehighip
Vendor
Just an observation, we have seen 3 IP500 V1's not power up after either power failure or shutdown to move them. Is this a pattern for anyone else?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
IP500 v1 fails after power down
- Thread starter milehighip
- Start date
- Status
only if you shut it down with the command, I had noticed that when I shut down the IPO with the shutdown command that I have to reboot it after powering up again to come back. It will work as soon as you just unplug it and power it back up and never needs a third reboot (or second depending what you count)
Joe W.
FHandw, ACSS (SME), ACIS (SME)
Give a tech a solution and he will be back tomorrow to ask you the next question, teach a tech how to read the manual and he will be able to solve the problems for a life time.
Joe W.
FHandw, ACSS (SME), ACIS (SME)
Give a tech a solution and he will be back tomorrow to ask you the next question, teach a tech how to read the manual and he will be able to solve the problems for a life time.
- Thread starter
- #3
milehighip
Vendor
These dont power up at all after loosing power, definitely a hardware problem. Run for years, through reboots, but when they have power removed from the power supply, they cool down and never come back to life.
- Status