IP403 DS 3.0(40) reset possible?

[IPOJIM]

Is there a way other than the AT commands through the DTE port to reset this box? Read that pre 3.2 does not speak AT commands. I have the DTE connected and can see the output and also deduced the IP address from the HEX address shown on the DTE. I tried the manager (latest) to dl the cfg but looked like the admin pass was not default.

Will try tomorrow with an older version if I can get it loaded. Is this even possible? (the reset to default) If the pass is not default am I out of luck? I tried the TFTP upload of the cfg and got a file not found on server. Tried the [systemname].cfg as the file to GET. Always fun sleuthing these older systems.

 

[kwing112000]

Follow this

http://www.tek-tips.com/faqs.cfm?fid=6158

Kevin Wing
ACA- Implement IP Office
Carousel Industries

 

[IPOJIM]

Thanks Kevin, when I did the procedure initially i must not have hit the escape key quick enough, this time I did, got in, erased the memory and got into the config with a manager from 2006, worked fine.