IP Trunking in Mx-One

[djudjuman]

I need information on this and will appreciate it greatly.
In 3 mx-one system say A,B and C

If A wants to communicate with B, Signalling is between the ELU32 or IPTU and media is via the IP network.
The Question: If there is an IP trunk from A to B only and B to C only. A wants to communicate with C, Hopefully, the Signalling is from Gatekeeper A( ELU32) to B and then from B to C. Does the MX-one keep the signalling like that throughout the communication or does it connect gatekeeper A to C directly later on.

 

[fouesnant]

Hi

Normally the signalling, as your explain your case, goes throught node B.
There is no solution with you call scenario to make the signalling going directly from A to C after the call has been established; releasing it and establishing it directly from A to C will cause a loss of the speech path before restablishing it again.
this will be noticeable by the called party as its phone will go onhook and ring again.

However, you will have a solution with MXone TSW with the feature Routing Server. This routing server,let's say Node B, will indicate to Node A and Node C, before any call session, how they can joint each other via the IP Network. Therefore signalling and media goes directly from calling to called node.

Best regards