Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
IP sets
- Thread starter TETech
- Start date
On the 1100 series sets, press the services key twice then scroll down to network configuration. I don't recall if there is a minimum firmware level required for that or not. On the i200X sets, I don't know of any way to get to the config without rebooting the phone.
golfdoctor
Technical User
Hi TETech,
Access your SS via telnet. This works on Release 4.0 and probably >
Using the cli, try the command [isetInfoShow "IP"] of the set you are trying to look at. I believe this should give you everything to view without causing a reboot of the phone.
TGD
Access your SS via telnet. This works on Release 4.0 and probably >
Using the cli, try the command [isetInfoShow "IP"] of the set you are trying to look at. I believe this should give you everything to view without causing a reboot of the phone.
TGD
- Status
Similar threads
- Question
