IP sets and IP Trunk at the same time BCM 50 2.0

[JAIME8004]

Hi How do I make work a BCM 50 2.0 with IP sets and IP Trunks with the same eternet in the BCM

 

[acewarlock]

Do you have KeyCodes for both?

Did you program the IP trunks?

Why change the engine if all you need is to change the spark plugs.

 

[JAIME8004]

Yes I have IP Trunks key codes 4 ports and IP Sets 16 ports at this moment the IP sets are working and I have a secure router 1001 for the IP Trunks with deferent IP addess how do I program this in the same BCM eternet.

 

[acewarlock]

where do the IP trunks go, to another BCM?

Why change the engine if all you need is to change the spark plugs.

 

[JAIME8004]

Thay go to a CSE CO and the problem is that in the bcm I only have the same eternet for the sets and the IP Trunks I know to program IP Trunk and IP sets but not the two at the same time.

 

[cook1082]

You have to program the remote gateway with the IP address of the far end BCM and the lead destination digits that you are going to dial. Plus in routing program dest code to dial out with absorb 0 and a route private pointing at the VoIP trunks.Then do the same with the far end BCM.

 

[JAIME8004]

OK the problem is that I programd the IP trunks and they work but then I need the same eternet for the the IP sets is a mistery I have only one eternet for the two services in the BCM

 

[acewarlock]

They boyh use the same network.

Why change the engine if all you need is to change the spark plugs.

 

[MagnaRGP]

I would suggest that you peruse the manual entitled Data Networking for VoIP and also the IP telephony manual on your BCM. The concepts are explained in detail and will give you a better understanding of what you are attempting to accomplish.

 

[JAIME8004]

Thank You acewarlock I changed the Ip sets to the same network and know it is working good.