IP PHONES on BCM 50

[FoneDude66]

We have three P2P t's and one BCM 50. We are trying to set up voip phones 4-6, where as 1-3 are already in use. However, when we plug the phone into the ethernet port, we are not getting anythign on the display. Even if the port/phone is not configured correctly, should I not still get some kind of power indication? thx

 

[danthephoneman]

For the IP phones to work you either need a POE switch,a power supply for the IP set, or a power injector for it to work.

If your trying to plug directly into the BCM 50 it is not going to work without a power source.

 

[FoneDude66]

Thank you. I found out that the powwer supplies were not ordered.