IP Office 500v2 Upgrade

[Roysanders]

Ran into this the other day. While upgrading an IP 500v2 from 6.0 r8 to 6.0 r18 with the manger 8.0 R18 and entering the password in the upgrade page as I read the sheets it was telling me to enter the system password. Doing this would end up with a "fail to load" message. After many attempts and no invalid password prompt I started playing around with different passwords and found "password" worked. Is this the default on this system or did someone change it on me?
Thanks for your help.

 

[tlpeter]

That is the default password.


Homo sapiens non urinat in ventum

honey, i fried the IP Office !!!

Sarcasm, it's only one of the services I offer.

 

[Roysanders]

Thanks for your reply. User error again!

 

[DrDrayAvaya]

tlpeter, have you had an ip500V2 upgrade where some of the bin files being sent to the SD card failed, yet others didn't?
I have had a few do this, and only way to make it behave was by doing a recreate via Manager, and send saved config back up from offline.

it didn't appear to be the same bin that failed each time, but it would try transferring, then timeout and fail. but next bin would possilbly succeed, then the next. then fail transfer again.
This was with "Validate" check box enabled in Upgrade Wiz.

Once recreated, the bins went thru perfect each time...

Would like to hear similar oddities, nail this SD card drama out finally!

 

[Roysanders]

This is the only one I've done, so no I haven't seen that happen.