Invisible mode and NAT mode (NS100)

[aZLAn2000]

Hi,

I was wondering if it is possible in any way to have the netscreen do Invisible mode from Outside-IF to DMZ-IF and then do NAT between the Outside-IF and Inside-IF. Does anyone know that?

/Christian

 

[Njetscreamer]

THe short answer is no you cannot mix transparent and nat/route mode on a netscreen.

The reason for this is that transparent mode is layer2 only and as soon as an IP is set on an interface it sets the netscreen up as a layer 3 device.
Hence you can only do nat or route mode on it.


sounds like mips or vips are what you need.

regards

Njetscreamer

 

[aZLAn2000]

Okay. It make sence. Guess i'll have to keep it in invisble mode at ask my other router to do the tricks. I also thought about NAT/Route but it would cost me too many IP's in my /29 network.

Thanks,
Christian