Invalid input. Quantity must be a multiple of build qty 1

[mejiaks]

I am getting an err message when running the end day process of IC accpac 5.3B

when i run data integrity check i can see this two lines of error saying

assembly 6977
Invalid input. Quantity must be a multiple of build qty 442.000

assembly 6978
Invalid input. Quantity must be a multiple of build qty 442.000

what do i have to do in order to fix this?

TIA

 

[Jay Converse]

Delete those assemblies.

 

[Jay Converse]

Wait, I found this old KB from '04

This is a result of someone changing the Build Quanity in the BOM setup after an assembly is
run but before Day End Processing.

To get around this, access the ICASEN table to find out what the Quantity the assembly was processed
for. Then change the BOM Build Quantity in Setup to match this number. Run DEP again.

If there had been multiple assemblies processed at different quantities that is not a multiple
of the Build Quantity prior to DEP, the above process must be repeated for each assembly. After
the last assembly is matched, DEP will complete.

 

[mejiaks]

Thks, that solved the problem